If your washing machine is not draining, the issue could be a blocked pump or a kink or blockage in the drain hose. Don't panic. Try these fixes and we'll see if you can get it working again.


  1. Clean out the drain pump & filter
  2. Unclog or unkink the drain hose
  3. Check you haven't turned on the 'rinse stop' or 'no rinse' function


Here is a video from Bosch that may help.




1. How to clean out the drain pump & pump filter

  • Turn off your appliance and disconnect from the mains.
  • Open the service flap on your machine (usually bottom right of your washing machine)
  • Drain off the water in the machine using the drainage hose provided or by unscrewing the round pump cover (lots of water will come out so be ready with towels and a large flat container to catch the water). The pump cover can be difficult to unscrew (usually unscrews counterclockwise)
  • Clean the pump filter & inside the housing so the impeller can rotate freely.
  • Reinsert the pump filter and screw tight (handle should usually be vertical)
  • Clip the drain hose back in position & make sure you put the stopper in properly!
  • Close the service flap & you're ready to go.


2. How to fix a clogged or kinked drain hose


  • If the drain hose from your machine is plumbed in permanently to the drainage of your property, you need to disconnect it.
  • If your drain hose is not plumbed in permanently, check that the drain hose is not pushed too far down into the drainpipe/standpipe (insert no more than 4.5"/113cm or water can siphon back into the machine). Also make sure the drain hose is not tight in the drainpipe as it needs air to enter to work properly.
  • Check the hose for fluff, debris, buttons or coins. These can block anywhere, but particularly around the rubber siphon.
  • Make sure the drain hose is not kinked or looped over itself as this can hinder drainage. 
  • Empty out any water still in the hose & if your machine has one, run the 'drain machine' function (you will need a bucket to catch all the water). 
  • Reconnect the drain hose and you are ready to go. 


3. Check you haven't turned on the 'rinse stop' or 'no rinse' function


Quite easy to do, but make sure any 'no rinse' or 'rinse stop' function is turned off or else your washing machine will stop before draining the water out.


--------------


Key words - washing machine is not draining, washing machine is not emptying of water, washing machine still full of water after programme/program, water still in my washing machine, blocked pump, blocked water filter, blocked drainage or drain hose, kink in drainage or drain hose, clogged drainage or drain hose